Audi A3 (8P) KW Coilover Kit V1

Purchase KW Coilover Kit V1 | 06-13 A3

SKU: 10210040
KW Coilover Kit V1 | 06-13 A3
Power gain Up To
+0 HP

Torque gain Up To
+0 TQ

Advertised gains are estimates of HP and Torque “at the engine” calculated from gains as measured on a Dynojet Dynamometer in ideal conditions and typically show the largest possible change. Actual gains are dependent on the following: Learn More about Crank HP Vs Wheel HP

Model – Manufacturers use the same engine in multiple model vehicles and often times they are in a different state of tune, for example: 2008 C63 and a 2008 CLK Black Series. Both have the same engine, but the C63 has 451hp while the CLK63 has 500hp. Naturally the C63 will show more gains as it starts at a lower level.

Model Year – Similar to above, as time progresses, Manufacturers tend to slightly increase power output via software from one year to the next or offer “Performance Packages” with increased power. The engines remain largely unaltered and as a result, final tuned output remains the same, while the gains are lower as the starting point is now higher.

Fuel – Fuel quality is HIGHLY important with performance vehicles. Low quality and/or low octane fuel will greatly impact engine output and potentially even engine health. Top tier brand premium fuels should always be used to achieve the best results possible.

Drivetrain – All wheel drive has higher drivetrain losses than rear wheel drive. This results in lower numbers when testing on a chassis dyno. Wheel/tire size and weight will also impact chassis dyno results

Weather/Conditions – Temperature, humidity, altitude, and air density all impact engine performance. Heat, high humidity, and thin air will all work towards reducing engine output

Engine Health – Higher miles tends to result in increased build up and lower compression which can and will impact engine output. Properly maintained engines will have better performance than abused or neglected engines.

Supporting modifications – The highest power levels require supporting modifications. Depending on the engine, this could mean forged internals, built transmission, upgraded fuel system, 110+ octane race fuel, etc.
Please confirm:
NOT LEGAL FOR SALE OR USE ON POLLUTION CONTROLLED MOTOR VEHICLES
Learn why

Confirmation
Please confirm that you are not installing this product within the United States.

This policy only applies to installers and/or users who are in the United States, customers who reside in other countries should act in accordance with their local laws and regulations.

Some Weistec Engineering performance upgrades may solely be used on vehicles in sanctioned competition which may never be used upon a public road or highway, unless permitted by specific regulatory exemptions (such as a CARB E.O.). For state specific details please visit the following website. http://www.semasan.com/emissions

It is the responsibility of the installer and/or user of the product to ensure that it is used in compliance with all applicable laws and regulations. If a product was purchased in error, do not install and/or use it. The purchaser must arrange to return the product(s) for a full refund.

All performance modifications and installations are at the customer’s own risk. Weistec Engineering holds no responsibility either implied or otherwise for mechanical, electrical or other failure when using any aftermarket performance products.
$1,789.00 $1,789.00
QTY:
Install instructions
Prop 65 warning

Warning
This product can expose you to chemicals including carbon black, silica - crystalline, formaldehyde, and lead which are known to the State of California to cause cancer, and lead, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Product details

Manufacturer	KW Suspensions
UPC	842607000478

Vehicle application

year	make	model	trim	engine
2013	Audi	A3	Base (8P)	2.0 TFSI EA113
2012	Audi	A3	Base (8P)	2.0 TFSI EA113
2011	Audi	A3	Base (8P)	2.0 TFSI EA113
2010	Audi	A3	Base (8P)	2.0 TFSI EA113
2009	Audi	A3	Base (8P)	2.0 TFSI EA113
2008	Audi	A3	Base (8P)	2.0 TFSI EA113
2007	Audi	A3	Base (8P)	2.0 TFSI EA113
2006	Audi	A3	Base (8P)	2.0 TFSI EA113
See more

Instructions

Install instructions

Product Description

The KW V1 INOX-LINE coilover kit is our entry point into our street performance lineup. The high-quality INOX-LINE stainless steel coilover struts, corrosion resistant springs, bumps stops and dampers that are optimally tuned by our engineers the result is a balanced and sporty feel specific to each vehicle application designed for long lasting driving pleasure. With KW V1 coilovers you can achieve maximum lowering within an approved lowering range that ensures a proper functioning suspension and adequate travel after your car is lowered. Even after years of use you can easily adjust the ride height thanks to the dirt resistant trapezoid thread and composite adjustment collar. KW INOX-LINE coilover rewards the sporty driver with its harmonious pre-configured setup. For each vehicle our engineers develop a specific damper setup and spring rate to increase the driving pleasure with an optimal balance of sportiness and practicality. As with all KW coilovers, the engineers at KW develop the vehicle-specific KW damper tuning and spring rates with comprehensive testing on the Nurburgring Nordschleife and in the KW 7-post chassis dynamics test center. Unlike a mass produced, generic coilover kit, KW coilovers are developed specifically for your vehicle. As a manufacturer, KW uses only its own resources, high quality components and the damper technology that was all developed in-house. With the KW V1 coilovers, body roll will be reduced during compression giving you the benefit of a more genuine and direct sporty handling while driving.

Application Guide

2006-2013 Audi A3 (8P) without electronic damping control 2WD, all engines
2008 Volkswagen Golf V (A5/1K, 1KP) R32 4motion
2012-2013 Volkswagen Golf VI , without DCC; R Model
2005-2010 Volkswagen Jetta V (A5/1K) Sedan / SportWagen incl. GLI and DSG
2010-2014 Volkswagen Jetta VI SportWagen 2.5i & 2.0TDI

Key Features and Benefits

KW suspensions V1 coilovers are hand built by our expert team and given a uniquely individual serial number at our headquarters in Fichtenberg, Germany.
Every single damper is dyno tested to ensure functionality and guarantee accuracy before being released for delivery.
With the preset damping paired with vehicle specific spring rates precisely tuned by our engineers, V1 coilovers provide an optimum balance of sportiness and comfort while driving. KW takes the guess work out of setup for you.
Composite spring perch made from wear-resistant, friction-optimized polyamide composite encompassing a stainless-steel insert. The polyamide composite prevents oxidation while the stainless-steel insert maximizes strength.
Inox-Line Stainless Steel - Truly Permanent Corrosion Resistance. Inox-Line coatings will not wear off while adjusting the suspension making KW coilover struts 100 percent corrosion resistant with an unlimited lifespan.
Seamless Ride Height Adjustment - the corrosion resistance of the Inox-line stainless steel and composite perches means easy ride height adjustability to help you dial in your preferred look.
Elastomer Bump stop with integrated dust protection system prevents water and dirt particles reaching the piston rod and seals. The highly resilient bump stops act as dynamic load limiters while maintaining ride quality and durability.
Limited Lifetime Warranty - Unlimited Mileage

Product Documents

Notes

2: Height adjustable front and rear axles (front axle threaded strut housings, rear axle adjustable springs + dampers)
37: For cars which have electronic dampers, make sure they are shut down. Specific electronical damper shut-downs are available from KW. Please check our accessories list
57: Only for cars with a clamp diameter of 54,6 mm on the front axle
67: Valving is adjusted by adjustment knobs, rebound is only adjustable if the top of the piston rod is accessible. This will depend on the design of the vehicle.

Lower Rates

Front: 1.4-2.6"
Rear: 1.4-2.6"

KW Coilover Kit V1 | 06-13 A3

Power gain Up To

Torque gain Up To